The Key Battlegrounds in the New GT3 Class at Le Mans
![](https://www.racecar-engineering.com/wp-content/uploads/2024/06/XPB_1202625_HiRes.jpg)
The biggest change to the 24 Hours of Le Mans grid this year is the arrival of LMGT3, which has supplanted GTE as the event?s production-based class. Aside from boosting car manufacturer numbers from four to nine, the introduction of GT3 machinery has brought some differences in how the race will likely run, as well as retaining some similarities. We look at the key battlegrounds.
To the layperson, GT3 and GTE cars may look very similar, if not the same. But the former has traction control and anti-lock braking, plus more weight and slower lap times by around four seconds at the Circuit de la Sarthe. The GT3 top speed is also 15-20km/h less than in GTE, whilst the GT3s will be doing much shorter stints. In most series, it is common for GT3 cars to do one hour before pitting, but at Le Mans they are expected to complete only around 40 minutes or 10 laps. This means that cars will be pitting more, likely in excess of 30 stops, whereas last year’s winning GTE-Am car completed 24 stops. GT3 cars at Le Mans have a limited amount of energy (measured in MJ) they can use during a stint. This number is defined in a Balance of Performance table. Saving energy is key because it means less time spent replenishing at pit stops. Teams calculate how much energy they can use per lap and instruct the driver to reduce the consumption rate, using familiar tactics such as lift and coast. Energy can also be saved during a safety car, when the pace is reduced. Fuel and energy consumption r...
Source:
racecar-engineering
URL:
http://www.racecar-engineering.com/
-------------------------------- |
|